Table of Contents
Advertisement
Quick Links
USA
SERVICE OFFICE
Dometic, LLC
2320 Industrial Parkway
Elkhart, IN 46516
574-294-2511
CANADA
Dometic, LLC
46 Zatonski, Unit 3
Brantford, ON N3T 5L8
CANADA
519-720-9578
For Service Center
Assistance Call:
800-544-4881
INSTALLATION
INSTRUCTIONS
3313973.038
REVISION
Form No. 3313973.038 08/11
(Replaces 3313973.020)
©2011 Dometic, LLC
LaGrange, IN 46761
This manual must be read and
understood before installation,
adjustment, service, or mainte-
nance is performed. This unit must
be installed by a qualified service
technician. Modification of this
product can be extremely hazard-
ous and could result in personal
injury or property damage.
These Instructions must stay with unit. Owner
read carefully.
RECORD THIS INFORMATION FOR FUTURE
REFERENCE:
Model Number
Serial Number
Date Purchased
Retailer / Qualified Installer
TYPE DA20
CASSETTE
AWNING
AVERTISSEMENT
!
Lire et comprendre ce manuel avant de
procéder à l'installation, à des réglages,
de l'entretien ou des réparations.
L'installation de ce produit doit être
effectuée par un réparateur qualifié.
Toute modification de ce produit peut
être extrêmement dangereuse et
entraîner des blessures ou dommages
matériels.
20025(XX).000(#)
20031(XX).000(#)
20035(XX).000(#)
20040(XX).000(#)
20047(XX).000(#)
20050(XX).000(#)
MODEL
Advertisement
Table of Contents
Related Manuals for Dometic DA20
Summary of Contents for Dometic DA20
- Page 1 RECORD THIS INFORMATION FOR FUTURE REFERENCE: Model Number Serial Number Date Purchased Retailer / Qualified Installer TYPE DA20 CASSETTE AWNING SERVICE OFFICE Dometic, LLC 2320 Industrial Parkway Elkhart, IN 46516 574-294-2511 CANADA Dometic, LLC 46 Zatonski, Unit 3 AVERTISSEMENT Brantford, ON N3T 5L8...
-
Page 2: Important Safety Instructions
These instructions must be read and under- of accidents and injuries. stood before installation of this hardware. This hardware must be installed by a Dometic, RECOGNIZE SAFETY INFORMATION LLC Service Center or a qualified service tech- nician. Incorrect installation can lead to se- vere injury. -
Page 3: Specifications
PROCEDURE B. Specifications A. Install Cassette Awning IMPACT OR CRUSH HAZARD. Make sure mounting bolts are located behind each IMPACT OR CRUSH HAZARD. Make sure RV’s shoulder assembly (lateral arm attachment) structure will safely and securely support aw- to provide proper support. Otherwise, the cas- ning before installation. - Page 4 c. Find a solid structure in RV wall for support of mounting bracket (if possible). See FIG. 3. Mounting bracket must be installed on a flat Important: A backing plate and sleeves (provided) are needed inside RV wall to strengthen awning sup- surface, and leveled to ensure proper function port.
- Page 5 IMPACT OR CRUSH HAZARD. Do not over- IMPACT OR CRUSH HAZARD. Make sure aw- tighten fasteners. Applying too much torque ning is securely mounted, and hooked onto may cause fasteners to fail, and could allow mounting bracket. Failure to obey this warn- awning to collapse.
- Page 6 Any adjustment of this hardware must be per- securely (with lead rail) before loosening formed by a Dometic, LLC Service Center or fasteners. Otherwise, the lead rail and lateral a qualified service technician only. Improper...
- Page 7 5. Tighten cap screws to 15.5 Nm torque to re-clamp 1. Extend awning far enough to access shoulder the shoulder to the shoulder base. See FIG. 12. base (approximately 300 mm). See FIG. 15. 6. Repeat steps (3) through (5) for each lateral arm assembly.
- Page 8 FIG. 16. cal parts. Any adjustments or repairs must be performed by a Dometic, LLC Service Center b. Turn adjustment screw in shoulder base IN to raise or OUT to lower lateral arm assembly.