Flat Washers; Materials Needed For Concrete/Masonry Wall - Grizzly G0443HEP Manual

3. tighten the ⁄ " lag bolts into the mounting
1
2
locations so they do not project more than
⁄ " from the mounting board to the top of the
1
2
head, but leave them out enough to slide the
housing over. this will prepare the mounting
board for the mounting instructions described
in assembly on Page 17.
Note: Predrill the mounting holes now, and
insert the lag screws when you mount the
motor/blower housing in the next section.
top row Mounting hole height
wall stud Centers
figure 10. Board fastened to wall and ready for
motor/blower housing assembly.
-16-
Materials Needed for Concrete/
Masonry Wall
• Concrete anchor studs
• hex nuts ⁄ " ............................................... 6
1
2
•

Flat washers

⁄ " ......................................... 6
1
2
• hammer drill .............................................. 1
• Masonry drill Bit ⁄
1
• level 4' ....................................................... 1
• pencil .......................................................... 1
• Measuring tape .......................................... 1
To mount the motor/impeller housing to a con-
crete or masonry wall:
1.
Copy the mounting hole layout pattern from
the motor housing to your wall, making sure
the Top Row Mounting Hole Height (see
figure 9 on Page 17) is correct for your dust
collector.
2.
Mount the anchor studs to the wall in the
mounting hole locations for the motor/impel-
ler housing. this will prepare the mounting
board for the mounting instructions described
in assembly on Page 17.
Model g0443 (Mfg. since 11/09)
⁄ " x 2 ⁄ " .............. 6
1 3
2 4
" ................................... 1
2