Wall Mounting; Materials Needed For Standard Wood Framed Walls - Grizzly G0443HEP Manual

Wall Mounting

Before mounting, make sure to situate the dust
collector away from any open flames or potential
ignition sources, as fine dust can easily ignite.
if mounting the dust collector to a wood framed
wall, you must build and install the wall mount-
ing boards described below to support the heavy
weight of the dust collector.
if mounting the dust collector to a concrete or
masonry wall, skip to Page 16.
Materials Needed for Standard Wood
framed Walls
• 2x12 Board 36" long for wall Mounting ..... 1
• 2x6 Board 36" long for wall Mounting ...... 1
• level 4' ....................................................... 1
• pencil .......................................................... 1
• Measuring tape .......................................... 1
• lag Bolts ⁄ " x 5" (board/wall) .................... 1
3
8
• Flat washers ⁄ " (board/wall) ................... 16
3
8
• lag Bolts ⁄ " x 2" (machine/board) ...........8*
1
2
• Flat washers ⁄ " (machine/board) ............8*
1
2
• drill ............................................................. 1
• drill Bit ⁄ " (for ⁄ " predrill) .......................... 1
1 3
4 8
• drill Bit ⁄ " (for ⁄ " predrill) ......................... 1
3 1
8 2
• stud Finder ................................................. 1
*Two of these fastener sets will be used
in mounting the intake barrel brace dur-
ing assembly.
To mount the motor/impeller housing to a
wood framed wall:
1. secure the wall mounting boards to the wall,
using the applicable layout diagrams for your
machine and wall type shown in figure 8.
Model g0443 (Mfg. since 11/09)
Wood Framed Walls, G0443
= Lag Bolts
= Lag Bolts, Countersunk
78 ⁄ "
1
2
9 ⁄ "
1
2
Ground
Wall Stud Wall Stud
figure 8. g0443 wall mounting board layout.
2.
Copy the mounting hole layout pattern from
the motor housing (see figure 9) to the wall
mounting board, making sure the Top Row
Mounting Hole Height is at the height indi-
cated in figure 9.
4 ⁄ "
5
16
Wall Mount Bracket
76 ⁄ "
3
4
Floor Top Row Mounting Hole Height = 76
figure 9. g0443 wall mounting layout.
36"
3 ⁄ "
1
2
2x12 Board
3 ⁄ "
1
2
2x6 Board
Wall Stud
22 ⁄ "
1
16
G0443
⁄
3
4
-15-
"