Table of Contents
Advertisement
Operating the device
Display
1
2
9
8
7
1
Cleaning reminder
2
Ambient temperature
3
Ready for measurement
4
Temperature unit °C (Celsi-
us)/°F (Fahrenheit)
EN-8
3
4
5
4
6
5
Battery display
6
Beep
7
Time
8
Date
9
Memory mode
Initial commissioning of the device
• Open the battery compartment (see page 17). Pull the transparent
battery contact separation strip that protrudes out of the battery
compartment and remove it from the housing in the direction indi-
cated by the arrow. Close the battery compartment again.
• The device turns on and switches to SET mode for entering the basic
settings (date, time, temperature unit).
Setting the date, time and temperature unit (°C/°F)
Before using the device for the first time, set the
date and time so that the measurements can be
saved together with the date and time.
• During initial commissioning of the device or af-
ter replacing the battery, the device automatically
switches to SET mode for entering the basic set-
tings (Figure 1).
• To access SET mode manually, press and hold the
START button for at least five seconds with the
device switched off.
• Press the START button again. You are now able
to set the year (Figure 2).
• Press the MODE button to increase the year or the
MEMO button to reduce the year. Once the cor-
rect value is set, confirm the entry by pressing the
START button.
• You are now able to set the month. (Figure 3).
Press the MODE button to increase the value dis-
Operating the device
Figure 1
Figure 2
Figure 3
EN-9
Advertisement
Table of Contents
