Table of Contents
Advertisement
WiebeTech LLC
Hardened Bay
Key lock
Access LED
Power LED
Standard Bay
Key lock
Access LED
Power LED
Basic Bay
Ejection handle
Chapter 3: Hard Drive Installation
If you purchased your RTX with pre-configured drives, you may skip to the next section.
Install a SATA (Serial-ATA) hard drive into each bay. With TrayFree™ technology, this process
couldn't be easier! Simply pull the ejection handle to open the bay door, slide in your SATA drive, and
shut the door behind it. The drive is
inserted with the label up and the SATA
connection on the drive inserted first.
With the RTX400 & RTX600H, you can
lock the bay for additional security, but
make sure to unlock it before pulling on
the ejection handle again.
R T X - U R U s e r ' s M a n u a l
Ejection handle
Ejection handle
(configuration only)
Power LED
Access LED
SCSI Ports
Ethernet Port
Power Outlet
WARNING: Do not block the ventilation
fan during operation. Overheating may
damage the device or hard drives.
All RTX TrayFree Bays accept 1TB SATA
drives, have power and access LEDs, and
connect to the host via a SATA connection.
NOTE: If any of the drives are inaccessible after
powering on the unit, try the following steps:
1. Turn off the power.
2. Remove the drive(s) in question.
3. Reinsert the drive(s).
4. Turn on the power.
Rear Panel
8cm Fan
RS-232
Infiniband
Expansion
(400 models only)
Power Switch
- 7 -
Advertisement
Table of Contents
