Table of Contents
Advertisement
!VA-M700R
(4) Adjustment Procedures
Test Point/
Step | Description | Connection | Signal Generator | Dial Control | P.W.Board
Adjusiment
Coordinates
The automatic adjustment is carried
out by connecting T.P.6007 to GND
for more than 3 sec.
(NOTE : Perform the automatic
T.P.1002
adjustment by increasing or
FM S-Meter
bed ickal
(3-G)
decreasing the input level by
Fi
8
(Input Level 52cR},
98.1MH;
1 | adjustment
uP
(
spe
3
? | p.6007
more than #508}, and then
Mod.
Ont}
(2-4)
perform the automatic
adjustment again with the
normal input level. In this
case make sure the output at
T.P.1002 shows 320.15V.)
The automatic adjustment is carried
AM Stop Level
1,000kHz, 34d):
T.P.6007
.
Fi
1,000KHz
'ut by connecting T:P.6007 to GND for
2 | adjustment
Ome 9 | (nod. 30%, 400H2)
6)
4
?
i
more than 3 sec.
NOTE : For the Test Points and Ajustment parts, refer to the Parts Layout on P.W.Boards and Wiring Diagram,
Advertisement
Table of Contents
