Service Policy - paco T-65 Assembly And Operating Manual

Avoid excessive use of solder when making a connection, especially when soldering to tube
socket pins and switch terminals. This often results in shorted conditions between adjacent
terminals or wiring. Also, switches will be ruined if solder flows into switch contacts. An ex ­
ample of unnecessary "piling on" of solder is shown in the illustration.
THE PACO WARRANTY
PACO Electronics Co., Inc., hereafter referred to as the Company, guarantees all parts
supplied with any PACO kit to be free of defects in material and workmanship under normal use
and service for ninety (90) days from purchase date. The Company's obligation under this
warranty is limited to those parts which are returned transportation prepaid with prior per­
mission of the Company, and in the judgment of the Company are defective under terms of this
warranty. This warranty is in lieu of all other warranties, and the Company neither assumes
no'" authorizes any other person to assume for them any other liability in connection with the
sale of PACO kits.
We urge the assembler to follow the instructions in this manual. The Company assumes
no responsibility for any damages or injuries sustained in assembling or operating PACO
instruments.
All prices and specifications are subject to change without notice. The Company reserves
the right to discontinue instruments and alter specifications at any time without incurring any
obligation to incorporate new features in PACO instruments previously sold.
The registration card accompanying each PACO kit MUST be filled in and returned to the
Company immediately after purchase. This warranty applies only to registered instruments.
INFORMA TION REGARDING THE PACO WARRANTY
All material and parts supplied with PACO kits have been carefully selected to meet
design requirements and should perform satisfactorily. However, on occasion, improper in ­
strument operation may be traced to a faulty tube or component. Should replacement of a part
be necessary, write directly to PACO Electronics Co., Inc., and supply the following inform~tion:
1.
Identify the model and serial number of the kit in which the part is used.
2. Identify the questionable part thoroughly. Use part number and description as given in
the parts list.
3. Completely describe the nature of the defect or your reason for requesting a replace ­
ment.
Please do not return the part in question until we notify you. Do not tamper with the com ­
ponent, as this voids our warranty.
When returning tubes, pack them carefully to avoid breakage in shipment. Broken tubes
will not be replaced. Parts broken or damaged through carelessness, misuse, or improper in ­
stallation by the kit builder likewise will not be replaced.
'SERVICE POLICY
PACO Electronics Co., Inc., offers its full cooperation and assistance to help you obtain
the specified performance from your instrument. We maintain a complete Service Department
with who!D you may correspqnd in the event you continue to experience operational difficulties
with your completed instrument. We will inspect and repair this TRANSISTOR AND CRYSTAL
DIODE TESTER Kit for a minimum service charge of $4.00 plus cost of parts, provided this in ­
strument has been constructed and completed according to instructions in this manual. This
special repair service is available for one year from purchase date. Repair service for PACO
instruments that have been used longer will be available for PACO owners at most economical
charges.
Instruments not entirely completed or that have been modified in design will not be
accepted for repair. Instruments showing evidence of the use of acid core solder or paste
fluxes will be returned not repaired.
Instruments for repair or service MUST be returned to us, transportation charges PRE­
PAID, according to the following shipping instructions.
Page 6