Table of Contents
Advertisement
(vY
20.
Connect R13 (4750, 1 % carbon precision resistor) from SB 4 (Solder) to SB 5 (Don't
Solder). Position this resistor close to switch so resistor leads will clear side of
chassis when mounted.
(:)/
21. Connect R18 (24.60, 1% wire-wound precision reSistor) from SB 7 (Solder) to SB 8
(Don't Solder).
( L) ~.
22.
Connect R19 (4.830, 1% wire-wound precision reSistor) from SB 8 (Solder) to SB 9
(Don't Solder).
("')
23. Connect R20 (2.410,1 % wire-wound precision reSistor) from SB 9 (Solder) to SB 10
(Don't Solder).
( rry
/ /
24. Connect R21
(~800,
1 % wire-wound precision reSistor) from SB 10 (Solder) to
SB 11 (Don't Solder).
PRE - WIRING OF "C" SWITCH (P14-285)
REFER TO FIGURE 3.
NOTE:
Before wiring, be sure switch shaft is turned to extreme counterclockwise poSition.
( ,)
25. Connect a length of solid, bare hook-up wire from SC 2 (Don't Solder) to SC 4
(Don't Solder).
( )
26. Connect R8 (333.30, 1% carbon precision reSistor) from SC 8 (Solder) to SC 9 (Don't
Solder). Position this resistor close to switch so resistor leads will clear side of
chassis wMn mounted.
@)
3.21n.,1%
(@
12.95n.,1%
0
@
50.5.n.1%
SC
4
FIGURE 3
( ,)
27. Connect R9 (50.50, 1% carbon precision resistor) from SC 9 (Solder) to SC 10
(Don't Solder). Position this resistor to inside of switch so resistor leads will
clear side of chassis when mounted. See Figure 3.
( , r
28. Connect R10 (12.950, 1% wire-wound precision resistor) from SC 10 (Solder) to
SC 11 (Don't Solder). Position this resistor close to switch so resistor leads will
clear side of chassis when mounted.
( I
,.<
r
I
29.
Connect Rll ( %
)
3.210, 1
Wire-wound precision resistor from SC 11 ( )
Solder to SC
2 (Don't Solder).
Page 10
l
Advertisement
Table of Contents
