Table of Contents
Advertisement
Figure 9. Before tightening panel nut, rotate switch so that red dot is located as shown
in Figure 5. Then orient switch so that flat side of shaft is directly opposite the NPN
"SHORT" marking on the panel. Check by placing one of the large pointer knobs on
the panel and tightening the set screw. Make sure the set screw is tightened against
the flat side of the shaft. Reposition switch
if
pointer does not line up with the
NPN ''SHORT'' marking. Retighten pointer knob on shaft.
WIRING
REFER TO FIGURE 10.
NOTE: Position aU wires close to panel in an orderly fashion.
( '/)
46. Connect an 8 1/2" length of green, solid hook-up wire from SF 7 (Solder) to lug H
on the meter terminal board (Don't Solder). Be sure to solder both lugs at
SF~.
( )
47. Connect a 3-1/4" length of yellow, solid hook-up wire from SF 8 (Solder) to E 1
(Don't Solder).
(t//48. Connect an 11-1/2" length of orange, solid hook-up wire from SF 5 (Solder) to SE 7
(Solder).
/ "
(vY 49.
Connect a 3-1/4" length of red, solid hook-up wire from SF 6
(Sold~r)
to E 7 (Don't
Solder).
(v-(/
50.
Connect a 7-1/2" length of red, solid hook-up wire from SF 20 (Solder) to lug J on
the meter term inal board (Solder).
j'Y--'
( i
1/
51. Connect a 14-1/2" length of green, solid hook-up wire from SF 23 (Solder) to lug
G on the meter terminal board (Solder).
(,:,-y 52.
Connect a 10-1/4" length of yellow, solid hook-up wire from SF 13 (Solder) to clip
K
on the meter terminal board. Pass this wire from bottom of terminal board,
through hole in board, and into the clip (Solder). Be sure to connect this wire to
both lugs at SF 13.
(1)/53. Connect a 5-1/2" length of orange, solid hook-up wire from SF'31 (Solder) to E 4
(Don't Solder).
( \ )
54. Connect a 14-1/2" length of yellow, solid hook-up wire from SF 34 (Solder) to SE 10
(Solder).
C)
55. Connect
a
13" length of orange, solid hook-up wire from SF 28 (Solder) to SE 4
.'
(Solder).
C)
56.
Connect a 14-3/4" length of green, solid hook-up wire from SF 43 (Solder) to SE 1
(Solder).
/ /
(./)
57. Connect a 13" length of yellow, solid hook-up wire from SF 45 (Solder) to SA 6
(Don't Solder).
(!/)/ 58.
Connect a 12-1/4" length of orange,solid hook-up wire from SF 41 (Solder) to SE 9
(Don't Solder) .
...
/
(v'f
59. Connect a 12" length of red, solid hook-up wire from SF 42 (Solder) to SE 8 (Don't
Solder) .
( i,-)//
60. Connect a 4-1/2" length of red, solid hook-up wire from SE 8 (Solder) to SA 18
(Solder).
Page 15
Advertisement
Table of Contents
