Table of Contents
Advertisement
(.,/(
9.
Connect a length of soUd, bare hook-up wire from SF 21 (Don't Solder) through
SF 33 (Don't Solder) to SF 44 (Don't Solder). Now solder SF 33.
( i Y
10. Connect a length of solid, bare hook-up wire (use spaghetti) from SF 48 (Don't
Solder) to SF 44 (Solder).
(vr/l1.
Connect a length of solid, bare hook-up wire (use spaghetti) from SF 48 (Solder)
to SF 37 (Don't Solder).
(v)/12.
Connect one end of a lengthof solid, bare hook-up wire through SF 38 (Don't Solder)
toSF26 (Don't Solder). Connect the other end through SF 37 (Don't Solder) to SF 25
(Solder). Now solder SF 37 and SF 38.
( vY/12A. Connect R4 (64000, 1
%
carbon precision resistor) from SF 27 (Solder) to SF 26
(Solder).
(;.1/
13. Connect a length of solid, bare hook-up wire (use spaghetti) from SF 36 (Solder)
to SF 40 (Don't Solder).
( .. Y
14. Connect a length of solid, bare hook-up wire from SF 40{Solder)toSF 29(Don't Solder).
(;.¥
15. Connect a length of solid, bare hook-up wire (use spaghetti) from SF 39 (Solder) to
SF 43 (Don't SOlder).
(vr/-'
16. Connect Rl (5600, 10% carbon reSistor) (green-blue-brown) from SF3 (Don't
Solder) to SF 15 (Don't Solder).
PRE - WI RING OF
II
Bit SW ITCH (P14-286)
REFER TO FIGURE 2.
NOTE:
Before wiring, be sure switch shaft is turned to extreme counterclockwise position.
( ,.)
17. Connect R16 (24. 7K, 1
%
carbon precision reSistor) from SB 1 (Solder) to SB 2 (Don't
Solder).
( t
Y
. /
18. Connect R15 (5K, 1 % carbon precision resistor) from SB 2 (Solder) to SB 3 (Don't
Solder). Position this resistor close to Switch so resistor leads will clear side of
chassis when mounted.
@24.7K,I%
@5K,I%
€ 9
2250,n..1%
@
475,n.,'Of.
@
@
2.41,n..1%
sa
.@
Q
4.83,n. 1°;'
~
,
24.6,n.,1%
FIGURE 2
(~
19. Connect R14 (22500, 1
%
carbon precision reSistor) from SB 3 (Solder) to SB 4 (Don't
Solder). Position this resistor to inside of switch so resistor leads will clear side
of chassis when mounted. See Figure 2.
Page 9
Advertisement
Table of Contents
