Table of Contents
Advertisement
after obtaining a sizable meter reading, since the meter may slam and possibly be damaged.
(Turn power off and replace silicon rectifier
if
removed for test.)
28. Check sockets and leads from front panel with an ohmmeter. All terminals marked "1"
must show short when connected to any other terminal marked "1". Repeat for terminals
marked "2", then for terminals marked "3", and finally for terminals marked "4
f ! .
This
completes check-out procedure.
CARRYING CASE ASSEMBLY
REFER TO FIGURE 14.
(
..
r}/119. Install handle hinges and handle on top of carrying case. The handle hinges mount
,
over holes on top of case with two #6-32 x 3/8" oval head screws, two #6-32 hex
nuts, and two #6 lockwashers for each hinge. See Figure 14. To assemble, first
mount one of the hinges, then place one end of handle on mounted hinge. Next,
insert other hinge into hole at other end of handle and mount this hinge to carrying
case.
16-32
:~
'~LOCKWASHERj~
16-
32 HEX NUT
X
3/FJ" OVAL HEAD SCREW
HANDLE
I
~UBBERfOOT
FI GURE 14
( ...}/ 120. Insert the four rubber feet into holes in bottom of carrying case. Install each foot
so flat portion is outside case. See Figure 14.
FINAL ASSEMBLY
(d
121.
Pass line cord through large hole in- rear of carrying case. Slide instrument in
until flanged edges of panel fit snugly around front edges of carrying case.
(
{~)~.
122. Secure rear of chassis to rear of carrying case with the two #6 x 3/8" BH, self
tapping screws.
Page 26
Advertisement
Table of Contents
