BorMann PRO BTC6200 Manual page 3

EN
ASSEMBLY INSTRUCTIONS
4. Attach the crossarms to the cradle:
NOTE: The crossarms are interchangeable.
• Slide the tapered plates on the crossarms into the tapered sockets on the cradle. (Figure 4)
• Press each crossarm forward into the socket until the spring tab on the bottom of the crossarm snaps into place. (Figure 5)
Snap latch
upward to
secure cradle
3
1. Set up the tripod base:
• Set the base on the floor, resting on its casters.
• Press down on the slide yoke ring. Hold the ring down while you swing the two forward legs out
until the yoke ring snaps into the locking hole on the bottom of the slide tube. (See Figure 1)
• To prevent the tripod base from rolling backward during assembly, lower the backstop as shown.
2. Place the frame assembly onto the two "V" angles on the tripod base, and lower the frame
about 1 in. (2,54 cm) until it is secured by the angles. Before continuing, ensure that the frame
is pushed all the way down and is held securely by the angles.
Figure 1
3. Attach the handle to the cradle (Figure 3):
• Fix the metal handle bar with flat washer and nut M6.
• Then screw the rubber handle to the bolt hole.
Figure 2
Stud
Figure 4
WWW.NIKOLAOUTOOLS.GR
Top View
Figure 5
Figure 3