Listening To Radio Programs - Denon D-F10 Manual

LISTENING TO RADIO PROGRAMS
(Check the connections on Pages 4 and 5.}
Tunes (UTU-F10)
Example: Tuning in FM 87.50 MHz
(AM stations are tuned in using the same procedure.)
Set the VOLUME control on the
pre-main amplifier to the
minimum position, then press
the SYSTEM POWER switch to
turn on the power
SYSTEM POWER
Press the BAND button
on the tuner to select the FM band,
Use the TUNING UP and DOWN
buttons to tune the frequency
to 87.50. Once the EM
frequency is tuned in, adjust : a
the volume to the desired level
using the VOLUME control.
ro This lights when a station is tuned in.
B7.So.
re sim
Auto Tuning
When one of the TUNING buttons is pressed, the frequency changes in steps of 50kHz in the FM band, 9kHz in the AM band.
@ If one of the TUNING buttons is held in for over 1 second, the frequency continues to change when the button is released
{auto tuning) and stops when a station is tuned in. Tuning will not stop at stations whose reception is poor.
@ To stop the auto tuning function, press the UP or DOWN button once.
Example: Presetting FM 87.50 (currently tuned in) at preset number 3
Flashes
The indicator flashes for Sy
ENTINEXT
ara
10 seconds.
Use the UP and DOWN buttons
to call out the mumber at
which you want to preset
the station (3), or simply
press the corresponding
number button @ on the
"P3" fights
B%.
Press the MEMO ENT/NEXT
button while the
indicator is flashing.
O.P 3
Up to 30 AM or FM stations can be preset using this procedure.
NOTES:
@ In addition to the reception frequency, the reception mode {monaural or auto} is also preset, so check the display when
Ppresetting stations.
® If a station is preset at a number where a station is already preset, the previous station is replaced with the new station.
e The preset memory is not cleared immediately when the power cord is unplugged, but is cleared if the cord is left
4 Oo unplugged for an extended period of time. If this happens, preset the stations again.
Listening to Preset Stations
The preset stations can be recalled using the number buttons on the remote control unit.
Also, if the following operation is performed when the system power is off, the power automatically turns on and the radio is
played. {Auto on function)
Example: Listening to the station preset at number 3
{This operation is only possible from the remote contro! unit.)
Press the TUNER button
on the remote control unit.
B87.S56G..P 3.
Press button "3" on the remote
control unit.
Using the RDS functions
Receiving RDS broadcasts (FM only)
Press the BAND button and
set the FM band.
Press the ROS button once.
Fiashes
"RDS" blinks
Press the AUTO TUNING UP or
DOWN button.
MY
"TUNING:
"RDS" displayed
The station is tuned in.
"RDS" lights ater 5 seconds of flashing
Once the station is tuned in, "ROS" flashes for 5
seconds and the program service name is displayed.
NOTE: If no RDS station is found, "NQ PROG" is displayed.
Q
m
2
m
a
>
-
"
m
.?)
=
fe)
2
A NEE SSD () | —|-) S