Advertisement
1.
Once pump stopped, stick should be unplugged first, and then
coupling can be released by pushing the black round
button.
2.
Due to safety reasons, fuel inlet lid should be moved back
to closed position as shown in the picture.
Lightning
To start the fire, fire adjustment handle should placed on "MAX" position. Espoo ceiling fireplace is equipped with easy spark – ignition system.
So once the adjustment handle is in the "MAX" position, you can light the
fire using the ignition button.
IMPORTANT
If the bioethanol used to fill the tank is very cold, It should reach
room temperature before it can be ignited, in the case where it bioethanol is very
cold or room temperature is too low, you may use a
gas lighter to start the fire.
It will take 10-20min before flames reach the intended size.
with full tank, it will take 6-10 hours until the whole fuel inside the tank burns out.
To adjust the flame level, adjustment handle can be used, the closer to "MAX", the higher flame & the closer to "OFF" position, the lower the
flames.
Extinguish
Should it be necessary to extinguish the fire before the burner is empty,
"OFF". Then wait 1 minute before shutting down the fire completely. After 1 minute, move the adjustment handle to "OFF" position. The
fire should be extinguished immediately. Refer to the picture below.
DO NOT
try to shut the fire in this period. Once the fireplace is started
set the adjustment handle to middle position between "MAX" and
Step 1: hold in
mid-position for
60 seconds.
7
Flame adjustment
Ignition button
Release button
Step 2: extinguish
the fire by moving
the arm to off
position.
Advertisement
