Table of Contents
Advertisement
15.Maximum save ambient temperature is 40°C. Don't use this unit at higher ambient tem-
peratures.
16.The units' surface temperature may reach up to 85°C. Don't touch the housing with bare
hands during its operation.
17.Make sure to always place the unit on a stable surface, never install the fogger above
the audience, a little liquid can always drip from the fog output.
18.Allow the device about 10 minutes to cool down before you start servicing.
19.Always unplug the unit when it is not used for a longer time or before you start servicing.
20.Check that the available voltage is not higher than the one stated on the rear panel of
the unit.
21.The power cord should always be in perfect condition. Switch the unit immediately off
when the power cord is squashed or damaged. It must be replaced by the manufacturer,
its service agent or similarly qualified persons in order to avoid a hazard.
22.Never let the power-cord come into contact with other cables!
23.This unit must be earthed in order comply with safety regulations. In order to prevent
electric shock, do not open the cover.
24.Never repair a fuse or bypass the fuse holder. Always replace a damaged fuse with a
fuse of the same type and electrical specifications!
25.In the event of serious operating problems, stop using the fixture and contact your
dealer immediately.
26.The housing must be replaced if they are visibly damaged.
27.Please use the original packing when the device is to be transported.
28.Due to safety reasons it is prohibited to make unauthorized modifications to the unit.
DESCRIPTION:
Advertisement
Table of Contents
Need help?
Do you have a question about the Bubble FOG and is the answer not in the manual?