Adjusting The Auxiliary Handle; Setting The Depth Stop; Instructions For Accessories - Parkside Performance PSBSAP 20-Li C3 Translation Of The Original Instructions

GB MT
2. Only for ratchet screwdriver (27):
Select the direction of rotation by mov-
ing the arrow to the desired mark
on the handle.
Adjusting the auxiliary
handle
Notes
• The auxiliary handle (19) can be ro-
tated 360 ° on the device and can be
moved to any desired position.
• Directional data viewed from behind.
Attaching the auxiliary handle
(Fig. C)
1. Turn the grip (34) of the auxiliary
handle (19) ⭯ .
2. Press the grip (34) towards the loop
(18) and hold this position. This ex-
tends the loop (18).
3. This extends the loop (18) of the aux-
iliary handle (19) behind the keyless
chuck. (2). Position the loop (18) in the
holder for the auxiliary handle (4).
4. Release the pressed grip (34).
5. Tighten the grip (34) of the auxiliary
handle (19) ⭮ .
Removing the auxiliary handle
(Fig. C)
1. Turn the grip (34) of the auxiliary
handle (19) ⭯ .
2. Press the grip (34) towards the loop
(18) and hold this position. This ex-
tends the loop (18).
3. Remove the auxiliary handle (19) from
the device by pulling the loop (18) on
the auxiliary handle (19) over the key-
less chuck (2).

Setting the depth stop

(Fig. C)
1. Release ⭯ the locking screw (35) for
the depth stop (20).
34
2. Push the depth stop (20) into the small
☜☞
opening on the auxiliary handle (19).
3. Position the depth stop (20) so that the
distance between the tip of the drill
and the tip of the depth stop corres-
ponds to the desired drilling depth.
4. Fix the depth stop (20) by tightening
the locking screw (35) ⭮ .
5. Loosen ⭯ the locking screw (35)
again to move the depth stop (20).

Instructions for Accessories

Measuring tape
1. Press and hold one of the locking
buttons (29.1) to temporarily fix the
pulled-out measuring tape (29).
2. Push the locking slider (29.2) forward
to permanently fix the pulled out meas-
uring tape.
3. Release the fixation by pulling back the
locking slider (29.2).
You can use the clip (29.3) on the back to
attach the measuring tape to your belt.
Carpet knife
If the carpet knife (22) is blunt, the blade
can be replaced or the blunt/damaged
segment of the blade can be broken.
The predetermined breaking points can be
recognised by the indentations, which are
evenly spaced across the blade.
Notes
•
blade breaks off, parts may fly through
the air. Wear eye protection.
•
blades of a carpet knife are very sharp.
Wear safety gloves.
•
blades are still a major source of
danger. Dispose of the blade immedi-
ately.
CAUTION! Risk of injury! When a
CAUTION! Risk of injury! The
CAUTION! Risk of injury! Worn