Electronic Oven Control; Display; Oven Indicator Lights; Start - Whirlpool Gold SF114PXS Use And Care Manual

A B
I H
A. Oven light
B. Clock
C. Display
D. Start (control lock)
E. Off/Cancel
When power is first supplied to the appliance, a flashing time will
appear on the display. Press OFF/CANCEL to clear flashing time
from the display.
If flashing time appears, a power failure has occurred. Press
OFF/CANCEL and reset the Clock if needed.
When the oven is not in use, the display shows the time of day.
When performing a cook or timer function, the display will show
either hours and minutes, or minutes and seconds.

Oven Indicator Lights

The indicator lights are located on both sides of the display. The
indicator lights light up or flash when the oven is in one of the
following modes: Bake, Broil or Timer.
The START pad begins any oven function. If the START pad is not
pressed within 5 seconds after pressing a function pad, the Push
to Start ("PSH") indicator light will flash and the push to start tone
will sound as a reminder.
If the START pad is not pressed within 1 minute after pressing a
function pad, the oven display will return to the time of day mode
and the programmed function will be canceled.

Off/Cancel

The OFF/CANCEL pad stops any function except the Clock,
Timer and Control Lock.
This is a 12-hour clock and does not show a.m. or p.m.
To Set:
Before setting, make sure the oven and Timer are off.
1. Press CLOCK.
2. Press the TEMP/HOUR "up" or "down" arrow pads to set the
time of day.
3. Press CLOCK or START.
8

ELECTRONIC OVEN CONTROL

C
D E
G F
.
F Temp/Time
G. Broil
H. Bake
I. Timer

Display

Start

Clock

Tones are audible signals, indicating the following:
One tone
Valid pad press
Oven is preheated (long tone)
Function has been entered
Three tones
Invalid pad press
Push to start reminder
Cycling tones
End of cycle

Fahrenheit and Celsius

The temperature is preset at Fahrenheit, but can be changed to
Celsius.
To Change: Press and hold BROIL for 5 seconds. A tone will
sound, and "°C" will appear on the display. Repeat to change
back to Fahrenheit. To exit mode, press OFF/CANCEL.
The timer can be set in hours or minutes up to 12 hours and
59 minutes, and counts down the set time either in hours and
minutes, or in minutes and seconds. The timer does not start or
stop the oven.
To Set:
1. Press TIMER. The timer indicator light will light up. If no
action is taken after 1 minute, the display will return to the
time of day, bake or broil mode.
2. Press the TEMP/HOUR "up" or "down" arrow pads to set the
length of time.
3. Press START. When the set time ends, end-of-cycle tones will
sound.
4. Press TIMER pad twice anytime to cancel the timer and
reminder tones.
If the OFF/CANCEL pad is pressed the oven will turn off and the
cook function will be disabled.
To display the time of day for 5 seconds when the timer is
counting down, press CLOCK pad.
If the START pad is not pressed within 5 seconds after pressing
the TIMER pad or TEMP/HOUR arrow pads, the "PSH" indicator
light will flash and the push to start tone will sound as a reminder.
The timer can be reprogrammed while it is running.
To Reprogram:
1. Press TIMER.
2. Press TEMP/HOUR "up" or "down" arrow pads to adjust
time.
3. Press START.

Tones

Timer