Sony SRS-XB23 Manual page 19

Hide thumbs Also See for SRS-XB23:

Table of Contents

Hint

As long as the BLUETOOTH function is activated on a BLUETOOTH device that has previously been connected with the

speaker, the speaker is reconnected with the device right after it is turned on.

The above instructions on the BLUETOOTH device are provided as an example. For details, refer to the operating instructions

supplied with the BLUETOOTH device.

Note

The pairing mode of the speaker is released after about 5 minutes and the (BLUETOOTH) indicator flashes slowly. However,

when the speaker has no pairing information, such as at the factory settings, the pairing mode is not released. If the pairing mode

is released before finishing the process, repeat from step

The passkey of the speaker is "0000." If a passkey besides "0000" is set on the BLUETOOTH device, pairing cannot be done with

the speaker.

Once the BLUETOOTH devices are paired, there is no need to pair them again, except in the following cases:

Pairing information has been deleted after repair, etc.

The speaker is already paired with 8 devices and another device is to be paired.

The speaker can be paired with up to 8 devices. If a new device is paired after 8 devices have already been paired, the device

that was paired earliest is replaced by the new one.

The pairing information with the speaker has been deleted from the BLUETOOTH device.

The speaker is initialized.

All pairing information will be deleted. If you initialize the speaker, it may not be able to connect your BLUETOOTH device. In

this case, erase the pairing information of the speaker on your BLUETOOTH device, and then perform the pairing procedure

again.

The speaker can be paired with multiple devices, but can only play music from one paired device at a time.

Srs-xb13