Installation - PR XRLED 400 BWS Manual

TROUBLESHOOTING
●
PROBLEM
The projector doesn't switch on
Thelamp is on butthe projectordoesn't respond
to thecontroller
The projector functions intermittently
Beam appears dim, Low in brightness
The project image appears to have a halo
Heavily Defective Beam
3. APPEARANCE

4. INSTALLATION

A projector can be placed on the stage floor directly or mounted on a truss at any direction without impacting its performance. Please
use a safety cord, which can support 10 times the weight of the projector, while mounting it on the truss. The safety cord should be
used with magazine with a lock. Just as the figures below, please run the safety cord through the holes at the bottom of the base and
around thetruss.
● RIGGING
1. Use M12 bolt to fix the clamp(1)intothe omega holder(3), run the bolt throughthe holder's holes
2. Push2 quick-lockfasteners(4)into holes at the bottomof thebase, fix themandtightenthemclockwise
3.Runsafetycord(2) throughholes at the bottom of the base andaroundthe truss(6)
Checkthefuseon thepower socket.

Check thelamp.

Makesurethatthefixture's startaddressis right

Replaceor repair theXLR signalcable.

Makesurethefanisworkingwellorfansandtheirshieldsarenotblocked

Makesurethelamp is within itslifespan

Removedustor greasefrom the lenses.

Carefullyclean thelamp,opticallensesandother components.

Check if lens are in good condition(not cracked)

Cleandustor greaseon the lens.

5
ACTION
Head
Arm
Base