Table of Contents
Advertisement
1. SAFETYAND WARNINGS
Before a projector's installation, power-on, operation and maintenance, please carefully read the
safety information hereinafter!
The following safety signs are used in the user manual.
Warning
User
Manual
● When unpacking , check if there is transportation damage before using the projector. Should there be
●
any damage causedby transportation,consultyourdealerand do notuse it.
● The manufacture is not responsible for loss caused by the user not following the manual or changing
●
the projector as he/shelikes
● Pleasebe notedthat thedamagecausedby changingtheprojectorat willis notwarranted.
●
● Do not hesitateto contactthe dealeror the manufacturerif any questionsor advice.
●
● If a lamp is damagedor deformsbecauseof heat,it should be replaced.
●
● Theprojectoris for indoor useonly,IP20.
● It cannot be used in humid and dusty areas. And it cannot contact water and other non-corrosive
liquids.
● The projector should be kept away from high temperature, fire, electrical surge, vibration and
strong light while being operated
● The projector is only intended for installation, operation and maintenance by qualified personnel.
And the operation must strictly follow the procedures in the manual
● No repairable parts in the projector and do not open covers for maintenance by yourself.
● Don't look straightly into the light sources especially for epileptics, otherwise eyes will be burned.
● Do not connect a projector to any type of dimmer pack.
● If the lamp, lens and screen protective cover of the a projector have obvious damage, i.e., to the
extent that it hurts the performance like cracking or deformation. Please stop using it and replace
them with the original parts, otherwise its performance will be compromised.
● For the installation location of a projector, it shouldn't be seen in the distance of less than 4 meters
for a long time.
● Before operation, please confirm that all covers (housing) are on and screws tightened. It's
forbidden to use a projector while covers (housing)are off .
● Keep the lamp clean and do not touch it with bare hands.
● While operating it, wear protective items like eye goggles , gloves and etc.
● Any electricalconnectionmustbe carriedoutby a qualifiedperson.
● Beforeinstallation,pleaseconfirm the voltagesuppliedmatcheswhatis requiredfor theprojector
● Eachprojectormustbe properlyearthedandinstalledas per related electricalstandards.
● Do notuse power cordwith itsinsulatordamagedandconnectthepower cord with othercables.
● If the projector is not used or under cleaning,, please hold the plug and unplug it. Do not unplug it forcefully
or by pulling thepower cable.
● All power cordsmust conformto relatedsafety and regulations
● While beingoperated,theprojectorshouldnotbe underrains or in humidity.
● Do not switch on and off the projector constantly in very short intervals, otherwise the light source's and
Goggles
Electrical
shock
3
NOTE
Protective
Flames
Gloves
High
Temperature
Advertisement
Table of Contents
