Table of Contents
Advertisement
●To avoid sunlight or other light penetrating into the head via the front lens, resulting in high temperature
internally causing damages to a projector. Before power-off, please use Tilt channel to move the head and
make the head facing downward.
● Do not use alcohol or other organic solvent to clean the housing to avoid damage.
● Do not use any solvent with chemical elements to clean coated filters.
●LUBRICATION
To ensure smooth movement of gobos and zoom and focus lens, it's advised rotators' bearings and 2 sliding bars for zoom and
focus lens be lubricated every 2 months. High quality and high temperature lubricant/grease is advised..
●TROUBLESHOOTING
PROBLEM
A projector doesn't switch on
The lamp is on but a projector doesn't respond to
the controller
A projector functions intermittently
Beam appears dim, Low in brightness
The project image appears to have a halo
Heavily Defective Beam
3.APPEARANCE
4. INSTALLATION
RIGGING
●
Before moving a projector, Please lock Pan and Tilt. Before its operation, please unlock them. It's forbidden to run a
projector with power while it is locked.
Check the fuse on the power socket.
Check the lamp.
Make sure that the fixture's start address is right
Replace or repair the XLR signal cable.
Makesurethe fan is working wellor fans and their shields arenot blocked
Make sure the lamp is within its lifespan
Remove dust or grease from the lenses.
Carefully clean the lamp, optical lenses and other components.
Check if lens are in good condition(not cracked)
Clean dust or grease on the lens.
5
ACTION
Head
Arm
Base
Advertisement
Table of Contents
