Installation - PR TANGO 100 BEAM Manual

●To avoid internal damage, sun light or other light mustn't penetrate into the projector via front lens whether it
runs or not
●Do not use alcohol or other organic solvent to clean the housing to avoid damage.
●Do not use any detergent with chemical elements to clean color filters with coatings.
LUBRICATION
●
To ensure smooth movement of gobos and zoom and focus lens, it's advised rotators' bearings and 2 sliding bars for zoom and
focus lens be lubricated every 2 months. High quality and high temperature lubricant/grease is advised..
●TROUBLESHOOTING
PROBLEM
The projector doesn't switch on
The project can be turned on, but the LED lamps
can't be on
The LED lamps can be on, but not controlled
by DMX
The brightness decreases obviously

3. INSTALLATION

●RIGGING
Before moving a projector, Please lock Pan and Tilt. Before its operation, please unlock them. It's forbidden to run a
projector with power while it is locked.
Take 1 clamp and 1 safety cord out from the package and tighten the clamp with the arm, and then mount the whole unit on the truss,
tighten the clamp's retainers to keep the unit stable. (See the WARNING on the underside of the base as shown above) To pass the
SAFETY CORD through theARM for safety! Always ensure that the unit is firmly anchored to avoid vibration and slipping whilst
functioning. Always ensure that the structure that you are going to mount the unit to is secure and strong enough to support the weight
of the unit
Check the power cord connection

Power Switch fails or is not connected well, call a professional

technician for repairing and checking
Control board is not connected normally, call a professional technician

for repairing and checking ,
LED lamp board is not connected well, call a professional technician for

repairing and checking
Check if DMX StartAddress is properly set

Check if XLR cable fails or not

Ambient temperature is too hot which makes the projector too hot,

please take appropriate ventilation measures
For safety, please run the safety cord through
the arm or its hole .
5
ACTION
Warning!
Clamp
Safety Cord