1. SAFETYAND WARNINGS
Before a projector's installation, power-on, operation and maintenance, please carefully read
The following safety signs are used in the user manual.
Warning
User
Manual
When unpacking, check if there is transportation damage before using a projector. Should there be any damage
●
caused by transportation, consult your dealer and do not use it.
The manufacturer is not responsible for any loss caused by the user not following the manual or changing a
●
projector as he/she likes.
Please be noted that the damage caused by changing a projector at will is not warranted.
●
Do not hesitate to contact the dealer or the manufacturer if any questions or advice.
●
If a lamp is damaged or deforms because of heat, it should be replaced.( It applies only to traditional lamps)
●
The projector is for indoor and outdoor use, IP65.
●
It can be used in humid and dusty areas.And it can contact water and other non-corrosive liquids.
●
The projector should be kept away from high temperature, fire, electrical surge, vibration and strong light while
●
being operated
The projector is only intended for installation, operation and maintenance by qualified personnel. And the
●
operation must strictly follow the procedures in the manual
No repairable parts in the projector and do not open covers for maintenance by yourself.
●
Don't look straightly into the light sources especially for epileptics, otherwise eyes will be burned.
●
Do not connect a projector to any type of dimmer pack.
●
If the lamp, lens and screen protective cover of the a projector have obvious damage, i.e., to the extent that it
●
hurts the performance like cracking or deformation. Please stop using it and replace them with the original parts,
otherwise its performance will be compromised.
For the installation location of a projector, it shouldn't be seen in the distance of less than 4 meters for a long
●
time.
Before operation, please confirm that all covers (housing) are on and screws tightened. It's forbidden to use a
●
projector while covers (housing)are off .
Keep the lamp clean and do not touch it with bare hands.
●
While operating it, wear protective items like eye goggles , gloves and etc..
●
Any electrical connection must be carried out by a qualified person .
●
Before installation, please confirm the voltage supplied matches what is required for a projector.
●
Each projector must be properly earthed and installed as per related electrical standards.
●
Do not use power cord with its insulator damaged and connect the power cord with other cables.
●
If a projector is not used or under cleaning,, please hold the plug and unplug it. Do not unplug it forcefully or by
●
pulling the power cable.
All power cords must conform to related safety and regulations.
●
the safety information hereinafter!
Goggles
Electrical
shock
3
.
NOTE
Protective
Gloves
Flames
High
Temperature