Whirlpool ACS102PP Use And Care Manual page 7

Room air conditioners for slider and casement windows
Table of Contents

Advertisement

Available languages

Available languages

Open window frame
1. Remove crank mechanism and catch handles.
2. Fold window sash back against exterior wall of building and
secure, or remove completely where possible.
Wood casement window installation
1. Construct a frame, using at least 1 in. (2.5 cm) thick wood
panel with a 15
in. (39.4 cm) wide opening.
2. Paint frame and fasten it securely, sealing it into window
opening.
If window opening width is greater than 15 in.
(39.4 cm):
1. Measure from side of window opening 15
From this point, measure to opposite side of window opening
to find width of filler panel. Measure height of window. Cut a
in. (19 mm) thick wood filler panel this width and the full
height of the window opening.
2. Attach securely to side of opening.
15
in. (39.4 cm) from side of window to wood filler panel
3. Paint to desired color.
Install support platform
1. Attach support platform to sill plate with three
tapping screws.
1
1. Support platform
2.
in. self-tapping screws
3. Sill plate
in. (39.4 cm).
15
1
/
" (39.4 cm)
2
in. self-
2
3
2. Loosely attach support angle to bottom of support platform
using two
in. machine screws, flat washers and nuts.
1
2
3
4
1.
in. machine screws
2. Support platform
3. Flat washer
4. Nut
3. Place support platform against lower window track and firmly
against vertical edge of window frame.
4. Attach support platform to windowsill using 2 - 1 in. wood
screws.
If required, overcome interference of support platform with
window track or storm windows by securely attaching a shim
strip to the windowsill. Shim strip should be as long as width
of support platform and flush with back edge of sill.
Thickness of shim strip should be controlled by amount of
interference.
1
2
3
1. 1 in. wood screws
2. Support platform
3. Lower window track
5. Pull support angle against outside of structure. Tighten two
in. machine screws on top of support platform.
6. Adjust leveling bolt to position support angle in a level plane.
This will allow for proper angle. Tighten leveling bolt nut.
NOTE: Air conditioner must tilted back slightly to facilitate
proper condensate disposal.
7. Cut 2 pieces of foam seal to height of window opening.
Remove backing and apply to window frame on both sides.
5
6
7
5. Sill plate
6. Support angle
7. Leveling bolt and locknut
4
5
4. Windowsill
5. Shim strip
7

Hide quick links:

Advertisement

Table of Contents
loading

Subscribe to Our Youtube Channel

This manual is also suitable for:

1187617Acs082ppAcs088gpw

Table of Contents