Toyotomi GAN-A28IVL User Manual page 12

Operation of Remote Controller
X-FAN:
16
Pressing X-FAN button in COOL or DRY mode,the icon
continue operation for 2 minutes in order to dry the indoor unit even though you have turned
off the unit.
After energization, X-FAN OFF is defaulted. X-FAN is not available in AUTO,FAN or HEAT mode.
Combination of "+" and "-" buttons: About lock
17
Press "+ " and "-" buttons simultaneously to lock or unlock the keypad. If the remote controller
is locked, is
Combination of "MODE " and "-" buttons : About switch between Fahrenheit and centigrade
18
At unit OFF, press "MODE" and " - " buttons simultaneously to switch between ℃ and ℉ .
Combination of " TEMP " and "CLOCK" buttons: About Energy-saving Function
19
Press "TEMP" and "CLOCK" simultaneously in COOL mode to start energy-saving function.
Nixie tube on the remote controller displays "SE". Repeat the operation to quit the function.
Combination of " TEMP " and "CLOCK" buttons : About 8℃ Heating Function
20
Press "TEMP" and "CLOCK" simultaneously in HEAT mode to start 8℃ Heating Function. Nixie
tube on the remote controller displays
heit is adopted). Repeat the operation to quit the function.
About Back-lighting Function
21
The unit lights for 4s when energizing for the fi rst time, and 3s for later press.
Replacement of Batteries
1. Remove the battery cover plate from the rear of the remote controller.
(As shown in the fi gure)
2.Take out the old batteries.
3.Insert two new AAA1.5V dry batteries, and pay attention to the polarity.
4. Reinstall the battery cover plate.
Notes:
• When replacing the batteries, do not use old or diff erent
types of batteries, otherwise, it may cause malfunction.
• If the remote controller will not be used for a long time,
please remove batteries to prevent batteries from leaking.
• The operation should be performed in its receiving range.
• It should be kept 1m away from the TV set or stereo sound
sets.
• If the remote controller does not operate normally, please
take the batteries out and reinsert them after 30 seconds.If it
still can't operate properly, replace the batteries.
displayed. In this case, pressing any button,
is displayed and the indoor fan will
and a selected temperature of " 8℃". (46 ℉ if Fahren-
12
blinks three times.
Sketch map for
replacing batteries
GB