Specifications; Troubleshooting - EDIFIER R101BT User Manual

Specifications

Power output:
Noise level:
Frequency response:
Sensitivity:
Tweeter:
Bass driver:
Input:
Frequency Band:
RF Power output:
There are no restrictions of use.
7
English
R/L (treble): 2W+2W SW: 4.5W
≤25dB(A)
50Hz~20KHz
AUX input: R/L: 500±50mV SW: 350±20mV
Bluetooth input: R/L: 450±50mFFs SW: 320±20mFFs
50×90mm
4 inch (106mm)
AUX/Bluetooth
2.402GHz~2.480GHz
≤20 dBm （EIRP)
Problem Solution
No sound • Check if the power indicator light is ON
• Try to turn up the volume using either the master volume
control or remote control.
• Ensure the audio cables are firmly connected and the
input is set correctly on the speakers.
• Check if there is a signal output from the audio source.
• Make sure the speaker is switched to Bluetooth input. If
Cannot connect via Bluetooth
it is in other audio input modes, Bluetooth will not connect.
Disconnect from any Bluetooth device by pressing and
holding the volume dial in Bluetooth mode, then try again.
• Effective Bluetooth transmission range is 10 meters;
please ensure that operation is within the range.
• Try another Bluetooth device for connection.
The R101BT does not turn on • Check if main power is connected, or if the wall outlet is
switched on.
To learn more about EDIFIER, please visit www.edifier.com
For Edifier warranty queries, please visit the relevant country page on www.edifier.com and review the
section titled Warranty Terms.
USA and Canada: service@edifier.ca
South America: Please visit www.edifier.com (English) or www.edifierla.com (Spanish/Portuguese) for local
contact information.

Troubleshooting

8
English