Table of Contents
Advertisement
Troubleshooting
Disturbance
Leftover food on dishes
dishes.
Removable streaks
are located on glasses,
glasses with a metallic
appearance
and cutlery.
50
Cause and troubleshooting
Washing program selected that is too weak.
Choose a stronger washing program.
▶
→ "Programs", page 19
Dishes have been pre-cleaned too much. The sensors
determine a weak program flow. Stubborn dirt
sometimes cannot be removed.
Only remove large food residues and do not pre-
▶
wash the dishes.
Tall, narrow vessels are not rinsed sufficiently in the
corner area.
Do not store tall, narrow vessels at an angle or in
▶
corners.
The upper dish rack on the right and left is not set at
the same height.
Adjust the upper dish rack to the same height on
▶
the left and right.
→ "Upper dish rack", page 23
The amount of rinse aid added is set too high.
Set the rinse aid system to a lower level.
▶
→
""Setting the amount of rinse aid added", page 29
No rinse aid is filled.
Add rinse aid.
▶
→
"Filling with rinse aid", page 28
Detergent residues are present in the rinse program section.
The lid of the detergent compartment was blocked by pieces
of crockery and did not open completely.
Place dishes in the upper dish rack so that the tab
1.
drip tray is not blocked by dishes.
→
""Putting away the dishes", page 33
The dishes are blocking the cleaner lid.
Do not place dishes or air fresheners in the tab drip
2.
tray.
Dishes have been pre-cleaned too much. The sensors
determine a weak program flow. Stubborn dirt
sometimes cannot be removed.
Only remove large food residues and do not pre-
▶
wash the dishes.
Advertisement
Table of Contents
