Controls And Functions; Repeater Operation; Transceiver Operation - Kenwood NXR-1700 Instruction Manual

CONTROLS AND FUNCTIONS

Front
①
⑥ ⑦ ⑧
Rear
⑨
① Display
repeater.
② POWER indicator
on.
③ POWER switch/selector
• When DC power is supplied to the repeater, the power
is automatically turned on. When power is no longer
④ LAN jack
⑤ USB jack (A-Type)
⑥ TX1/ TX2 indicator
During DMR transmission, the TX1 indicator lights red when
communicating with the radio in Timeslot 1, and the TX2
indicator lights red when communicating with the radio in
Timeslot 2.
transmission.
⑦ RX1/ RX2 indicator
On the DMR standby channel, the RX1 indicator lights green
while receiving a receivable CC matching signal in Timeslot 1.
The RX2 indicator lights green while receiving a receivable CC
matching signal in Timeslot 2.
receiving a signal with matching signaling and only RX1 is lit
while receiving a signal that does not match signaling.
② ③ ④ ⑤
⑩ ⑪
TX
CONTROL I/O
TX1 and TX2 are lit during
RX1 and RX2 are lit while
⑧ STATUS indicator
is abnormal.
⑨ DC jack
⑩ TX OUT jack
Connect a TX antenna or a duplexer to this N receptacle.
⑪ CONTROL I/O jack
Connect a repeater controller or a remote panel to this
⑫ RX IN jack
⑫

REPEATER OPERATION

RX
Note
The RX1/ RX2 indicator lights green while receiving a signal and
the TX1/ TX2 indicator lights red while transmitting.

TRANSCEIVER OPERATION

Note
adapter.
Receive
may need to readjust the volume if you are having interference
while receiving a message from your dispatcher or another
signal is being received.
Transmit
1
being used.
2 Change the Test PTT Control
indicator lights red while transmitting.
3
2
RX1/ RX2 indicator lights green while a
TX1/ TX2
Test PTT Control to