Positioning The Turf Compensating Spring - Toro Reelmaster 5510 Operator's Manual

Installing the Hose Guide (continued)
3. Align the studs
the holes in the cutting-unit frame and the turf-
compensator bracket
Note:
guide aligns toward the center
machine.
4. Assemble the hose guide and turf-
compensator bracket to the cutting-unit frame
with the 2 flange locknuts (3/8 inch)
5. Torque the locknuts to 37 to 45 N∙m (27 to 33
ft-lb).

Positioning the Turf Compensating Spring

Cutting Unit 2
Cutting unit 1
Cutting unit 2
1. If the hairpin
the compensation-spring rod, remove the
hairpin and insert it in the hole next to the
bracket.
3464-490A
of the right hose guide with
.
Ensure that the support loop of the hose
Cutting unit 3
Cutting unit 4
is installed in the rear hole of
of the
.
G410311
G410999
Cutting unit 5
Reel motor
G410292
Page 3–6
Weight
Setup: Installing the Cutting Units