Hayward ColorLogic SP0536AF Owner's Manual page 7

Install the Hayward ColorLogic Accent Light in vinyl lined pool.
1.
The SP0538AFXXX fitting is intended to be used in a pool that has a vinyl liner. Pool wall thickness must be
equal to or below 1/4" or between 5/8" and 1".
2.
Make one circular cut-out in pool wall minimum 3" in diameter and maximum 3-1/16" in diameter.
3.
Insert fitting body through the inside of the pool wall until the underside of the flange is flush against the wall.
If pool wall is 1/4" or less in thickness, screw combo locknut-spacer onto fitting body with polygon side to rear
(as shown below). To hold fitting in place against pool wall, tighten combo locknut-spacer firmly by hand—
then turn 1/2 of a revolution with suitable channel locks (DO NOT OVERTIGHTEN),. If pool wall is between 5/8"
and 1" thick, reverse orientation of combo locknut spacer and screw on as described above.
4.
Install the pool vinyl liner.
5.
Place face plate on the inside wall of pool, making sure the holes in the face plate are lined up with the holes
in the body of the fitting. Pierce the vinyl pool liner through face plate one hole at a time prior to inserting
screws.
6.
Fasten face plate to fitting body with the four (4) 1" screws provided. Screw through Face Plate, Vinyl Liner,
and into Fitting Body.
7.
Cut-out vinyl liner along inside edge of face plate.
8.
A minimum 14" long piece of 1 ½" schedule 40 PVC pipe is required to be solvent cemented into the SP0538A
body.
Item
1
2
3
4
5
Note: Alternate color face plates SPX1408BGR, SPX1408BDGR, and SPX1408BBLK are available
Part Number
SPX1039Z1A
SPX1408B
SPX1408C
SPX1407D
USE ONLY HAYWARD GENUINE REPLACEMENT PARTS
Description
1" Flat Head Screw Pack
Face Plate
Gasket
Fitting Body
Combo Locknut-Spacer
Number Required
1 (Pack of 4)
1
1
1
1
7