Installation - Hayward ColorLogic SP0536AF Owner's Manual

INSTALLATION:

INSTALLATION DEPTH REQUIREMENT:
that is not used for swimming and the lens is adequately guarded to keep any person from contacting it, the
fixture must be installed in a wall or on a floor of a pool, spa, or water feature with the top of the lens opening not
less than 4 in. and no more than 72 in. below the normal water level of the pool.
CORD LENGTH AND MINIMUM REQUIRED VOLTAGE:
When installing the ColorLogic Accent low voltage lights, the length of the cord has an effect on performance. To
prevent performance problems, verify the transformer is providing the minimum required voltage according to the
table below. To check this voltage, measure the voltage at the transformer while the light is "on" and operating in
"white" mode. In some cases, a voltage greater than 12 volts is required due to a long cord run. Some
transformers provide higher voltage taps for this purpose; check your transformer manufacturer's installation
instructions for details. When using Hayward or other transformers that offer a 14v option, we suggest that you
always use the 14 volt tap.
INSTALLATION OVERVIEW
Refer to the diagram below for an overview of the ColorLogic Accent light, to comply with NFPA-70 (NEC) and to
provide the easiest path for the light cord.
Except when the wall fitting is installed in an area of the swimming pool
PRODUCT
12v ColorLogic
Accent Light
USE ONLY HAYWARD GENUINE REPLACEMENT PARTS
Total cord Minimum
length from Required
Transformer to Voltage at
Light transformer
30 ft 12-14 volts
50 ft 13-14 volts
100 ft 14 volts
4