Installation Location - Hayward ColorLogic SP0536AF Owner's Manual

Installation Location

The wall fitting must be installed in a wall or on a floor of the pool or spa with the top of the lens not less than 4
inches (10 cm) below the normal water level of the pool except when the wall fitting is installed in an area of the
swimming pool that is not used for swimming. Select a location for the light fixture(s) that will give optimum light
dispersion for the pool or spa design. Be sure to consider the direction of emitted light and take care not to point
lights directly at the house or outdoor living spaces.
Install Junction Box or Junction Box Transformer
When using a wall mount low voltage transformer, a junction box should be installed to make the connection to
the pool/spa light. If using more than one light, an adequate amount of single or double outlet junction boxes
will be required. Alternatively, Hayward low voltage junction box transformer kits (LTBUY11H65) can be used
when in-line transformers are desired.
Junction boxes must be installed not less than 48 inches (1.22 m) from the edge of the pool or spa. Run conduit
from the mounting location up to the junction box such that the junction box is not less than 8 inches (20 cm)
above the maximum pool or spa water level, or not less than 4 inches (10 cm) above the ground, whichever is
greater. Additional conduit should be run from the junction box to the power supply, switch panel, pool/spa
controller, etc.
Install the Hayward ColorLogic Accent Light - Gunite Pools
The ColorLogic Accent Light installs in a 1.5" PVC pipe that will be installed through the pool wall.
For Gunite pools, the SP0536AFXXX wall fitting should be used.
USE ONLY HAYWARD GENUINE REPLACEMENT PARTS
1) Determine the desired installation location.
2) Solvent cement a 14" long piece of 1 1/2" Sch 40 PVC
pipe into the SP0536A Fitting Body.
3) Position the assembly through the proposed pool
wall. The backface of the SP0536A Fitting Body
should end up flush with the Gunite wall surface as
shown.
4) Cover the openings with duct tape.
5) Apply Gunite to pool walls.
6) The Plaster surface should be flush to the top of the
flange.
5