Table of Contents
Advertisement
ASSEMBLY INSTRUCTIONS
~
ASSEMBUNGTHEHANDLE
Push and hold the push-pin button on the side of the upper handle assembly (1)
os
you slide the
handle onto the frame (2).
NOTE:
Before use, pull the handle up until the lock button snaps through the locking
slots
to secure
the handle in place.
~
~
6.
ASSEMBLING THE HIGH PRESSURE HOSE
Take one end of the hose off the holder.
...
Turn the crank handle until the hose can be completely removed. Then remove the other end of
the hose from the holder.
•
Connect one end of the hose to the water outlet connector and the other end to the trigger gun.
Crank Handle
12
ASSEMBLY INSTRUCTIONS
7. CONNECTING HIGH PRESSURE HOSE TO TRIGGER HANDLE
Align the pressure hose with the trigger handle and push up and into position.
With hose pushed into position on the trigger handle, secure in place by turning the hose lock
clockwise until fully tightened
.
NOTE: For easier installation of the hose to the unit or trigger, it is suggested to add pressure washer
or dish detergent to the rubber seal at each end of the hose. This will allow for easier installation and
a snug fit.
G
~
~
w
e~
8.
ASSEMBLING THE SPRAY WAND
Push the end of the spray wand into the trigger handle and rotate clockwise to secure.
Pull on the spray wand to be certain it is properly secured.
I
13
Advertisement
Table of Contents
