Table of Contents
Advertisement
OPERATING INSTRUCTIONS
To add
detergent:
Place pressure washer upright on a flat surface
Remove cap from detergent tank
Pour detergent into tank
Reinstall cap
Detergent
Tank
AcAUTION:
Use
Black
Soap Tip Only
Use only approved pressure washer cleaners
.
Do not use bleach
,
chlorine,or any cleaners containing
acids.
To use:
Connect low pressure black soap spray tip to the wand
connector.
Squeeze the trigger and the detergent will automatically be mixed with the water and dispensed
from the spray
tip.
NOTE: Use a funnel
,
if needed, to prevent accidental spilling of the detergent outside the
tank.
If
any detergent is spilled during the filling
process,
make sure the unit is cleaned and dried before
proceeding.
16
OPERATING INSTRUCTIONS
11.STARTING AND STOPPING THE PRESSURE WASHER
CAUTION:
Do not run the pump without the water supply connected and turned on
.
Connect the garden hose.
Turn the water supply
on,
then squeeze the trigger and run water hose with motor in OFF position
until a steady stream of water appears. This helps drain air from tank and
lines.
NOTE: If the pressure washer pulsates and the water stream is intermittent turn the pressure washer
off and continue to bleed air out of the
system.
Ensure to check that the garden hose is fully turned on
and not kinked
.
After ensuring the On/Off switch is in the OFF ( 0 ) position
,
connect the pressure washer to the
power
supply.
Press the reset button on the pressure washer's plug to make sure the unit is ready for
operation.
Rotate to ON ( I ) position on the switch to start the
motor.
To stop the
motor,
release the trigger and rotate to OFF( 0 ) position on the switch.
NOTE: The pressure washer may be on and the system may have pressure even when the pump
and/or motor cannot be heard running
.
Always use caution around the pressure washer.
CAUTION:
Hold the trigger handle securely with both
hands.
Expect the trigger handle to move when the trigger
is pulled due to reaction forces
.
Failure to do so could cause loss of control and injury to yourself and
others.
NOTE: AUTO ON/OFF SWITCH
:
This pressure washer is equipped with an auto start/stop feature
.
To operate
:
Turn the power switch to the On (I) position. Pump will pressurize and shut down
immediately. Once the trigger of the gun is depressed
,
the unit will turn on
.
Unit will shut off and be in
standby mode when trigger is released.
17
Advertisement
Table of Contents
