Kobalt KBT2000 Manual page 12

OPERATING INSTRUCTIONS
12. USING THE SPRAY TIPS
Each of the spray tips has a different spray pattern . Before starting any cleaning job, determine the
best spray tip for the job. The following chart offers some general guidelines to help you choose the
best spray tip for your application.
NOTE: Always try spray tip in an inconspicuous area first.
Turn off the pressure washer and shut off the water supply. Pull trigger to release water pressure.
Engage the lock-out on the trigger handle by pushing the trigger lock button to the right.
Pull out the desired spray tip from the tip storage on the handle.
Pull back the quick-connect collar on the spray wand .
Push the spray tip into place in the spray wand.
Push the collar forward so that the spray tip is secured properly. Check to see that the spray tip is
secure
IJ
Spray Tip
" " '
2 ...
1-Pull back the quick-connect collar
1
t
2-Push the spray tip into place
...
"""'
3-Push the collar forward
~
3
./ /
E
SPRAY TIP APPLICATION
I
Green - Narrow fan tip (25°)
1
The green pressure washer tip provides high versatility with its 25 degree angle tip.
'V
Referred to as the washing tip because it provides adequate pressure to remove dirtl
from surfaces, but is designed to not damage many surfaces . This pressure washer
25'
tip is designed for "sweeping" foliage or debris given its wide angle. This tip is versatile,
due to its wide area of cleaning and strong pressure application .
White -Wide fan tip (40°)
~
The white 40 degree tip, referred to as the "fan" tip, creates the widest area of cleaning
with relatively low pressure. This pressure washer tip is best used for light or delicate
40'
cleaning applications . It is recommended for light cleaning on wood decks and other
soft or delicate surfaces.
Black - Soap spray tip ..
The black soap spray tip is used for soap application . Soap is applied under low
SOAP
pressure high volume for optimum performance. Soap cannot be applied under high
pressure with this machine.
Turbo Nozzle Tip
~
This nozzle rotates in a zero to 15 degree circular motion spray pattern to break
down tough dirt and grime. The spray pattern can cover area of 4 to 8 inches wide ,
TURBO
depending on the distance between the tip and the surface being cleaned .
18
OPERATING INSTRUCTIONS
A
wARNING
NEVER change spray tips without engaging the lock-out on the trigger handle and NEVER point the
wand at your face or at others. The quick-connect feature contains small springs that could eject the
spray tip with some force. Failure to heed this may cause personal injury.
TO DISCONNECT A SPRAY TIP FROM THE SPRAY WAND ONCE THE CLEANING JOB IS
COMPLETE:
Turn off the pressure washer and shut off the water supply. Pull trigger to release water pressure.
• Remove the spray tip by placing hand over spray then pulling back the quick-connect collar. Place
spray tip in the tip storage area on lhe units folding handle.
13. USING THE SPRAY WAND TRIGGER
For greater control and safety, keep both hands on the trigger handle at all times.
Pull back and hold the trigger to operate the pressure washer.
Release the trigger to stop the flow of water through the tip.
TO ENGAGE THE LOCK-OUT:
Push up on the lock-out until it clicks into the slot.
TO DISENGAGE THE LOCK-OUT:
Push the lock-out down and into its original position .
19
Slot