Table of Contents
Advertisement
Hopper Check
1.
Straighten and place cards correctly in the specified
hopper.
2.
Press MFCU start key to continue job.
Hopper Check and Print Check
1.
Press MFCU stop key.
2.
Mark the last card in each stacker that is being used
for output. If in doubt, mark the last card in every
stacker.
3.
Straighten or place cards correctly in the specified
hopper.
4.
Press MFCU start key to continue the job.
5.
Upon completion of the run, identify the output files
with 'print check'.
The cards to check for print
errors are the marked cards and the card immediately
preceeding each marked card.
Feed Check
1.
Open MFCU top cover.
2.
If the error mes sage indicates a secondary feed check,
remove the card from the primary (upper) wait station
and place it under the cards (if any) in the primary
hopper. If the error message indicates a primary feed
check, remove the card from the secondary (lower) wait
station and place it under the cards (if any) in the
secondary hopper.
3.
Remove all remaining cards from the card feed path
starting at the area between the hopper and wait
station and progressing through the punch and print
statins. Keep cards face down and in order.
4.
Check the number of cards removed with the card number
displayed in the error message. If equal go to step
6.
5.
If the number of cards removed is small er than the
message indicates, remove the number of missing cards
from the stacker indicated in the error message and
place them on the bottom of the stack of cards removed
in step
3.
6.
Place removed cards under the cards (if any) in the
indicated hopper and close the MFCU cover.
7.
Lift cards in the primary hopper and press the NPRO key
to turn off error indicator on MFCU panel. If error
indicator does not turn off, raise the cards in the
secondary hopper and press the NPRO key. If the NPRO
key does not work, check that the card path is clear,
because a wrongly positioned card can inhibit the NPRO
key.
8.
Press MFCU start key to continue the job.
Feed Check and Hopper Check
1.
Open MFCU top cover.
2.
If the error message indicates a secondary feed check,
remove the card from the primary (upper) wait station
and place it under the cards (if any) in the primary
S-6
4331 Processor Operators Guide
Advertisement
Table of Contents
