Table of Contents
Advertisement
..
stacker.
4.
Lift the cards in the hopper indicated in the error
message and press the NPRO key. One card is fed into
stacker 1. If the NPRO key does not work, remove the
card manually.
5.
Place this card under the other cards of the hopper
indicated in the error message.
6.
If blank cards are being punched, press MFCU start key
to continue the job.
7.
If pre-punched cards are being punched, place an
additional blank card under all cards in the hopper
indicated in the error message.
8.
Press MFCU start key to continue the job.
9.
When the job is completed, punch and verify the
pre-punched information from the marked card into the
card immediately following it. Discard the marked card
or
save
it for the CE.
Punch Check, Read Check and Print Check
1.
Press MFCU stop key.
2.
Mark the last card in each stacker that is being used
for output. If in doubt, mark the last card in every
stacker. The marked card(s) or each immediately
preceding card may be misprinted.
3.
Remove the last card from the stacker indicated in the
error message, mark the card, and return it to the
stacker.
4.
Lift the cards in the hopper indicated by the error
message and press the NPRO key. One card is fed into
stacker 1. If the NPRO key does not work, remove the
card manually.
5.
Ensure that this card was placed in the hopper
correctly, and was not off-punched, or damaged. If the
card is off-punched or damaged, re-punch card. Place
card ahead of deck in the specified hopper.
6.
Place an additional blank card under each card in the
hopper indicated by the error message.
7.
Press MFCU start key to continue the job.
8.
When the job is completed, punch and verify the
pre-punched information from the marked card into the
card immediately following it. Discard the marked card
or save it for the CE.
Print Check
1.
Press MFCU stop key.
2.
Mark the last card in each stacker that is being used
for output. If in doubt, mark the last card in every
stacker.
3.
Press MFCU start key to continue the job.
4.
Upon completion of the run, identify the output files
with 'print check'.
The cards to check for print
errors are the marked cards and the two cards
immediately preceeding each marked card.
Reference Information
5- 5
Advertisement
Table of Contents
