Page 1
VESA adapter Assembly instructions The VESA adapter is compatible with the following products from (hp.com): 22m, 24m, 27m The VESA adapter allows you to conveniently mount your HP brand monitor to a monitor arm with a VESA hole pattern (75 x 75mm). Use the included screws and nuts.
Assembly instructions Important Safeguards Please read these instructions carefully and keep them for future reference. If you pass the product on to third parties, these instructions should always be included. Failure to follow these instructions may result in injury or damage to persons or the product, for which we cannot accept any liability.
For the disposal of this product we recommend to contact the responsible local authorities or disposal services. They can provide you with detailed information on available disposal options and recycling centers in your area. 4. Manufacturer Information 3idee Technologies S.à r.l. 5 Um Lenster Bierg L-6125 Junglinster Luxembourg 5.
Assembly instructions Horizontal / Vertical Alignment Please note: Not all VESA adapters and monitors are designed for vertical (upright) orientation. This limitation is often due to the specific geometry of the adapter or monitor. Do not ignore this information, as the load limit of the adapter can quickly be exceeded if not installed properly. We are continuously working on developing monitors and adapters that are also suitable for vertical orientation.
Assembly instructions Assembly Instruction Step 1 Remove the base of your monitor if it is already attached. Step 2 Mount the adapter to your VESA monitor arm or directly to the wall. (Figure 1) Figure 1 Step 3 Plug the monitor onto the adapter so that it audibly clicks into place.(Figure 2) Hint: Apply some pressure if necessary! Figure 2...