Pylontech Pelio-L-5.12 Setup Manual page 8

If network config
success, the page will
turn to "Config Success"
Note: After selecting 'Start Config', if you confirm that the device has exit config network mode
(see the first step to confirm the status of the flashing light on the logger), you can click
"Close", and re-try the above step (2) then clicking "Start Config".
Please note: if the network config fails, please check the following reasons and re-configure
the network according to the above steps:
▪
Make sure WLAN is ON;
▪
Make sure the Wi-Fi network;
▪
Check whether the Wi-Fi network password is entered correctly;
▪
Make sure the wireless router is not blacklisted;
▪
Remove special characters in Wi-Fi network name;
▪
Shorten the distance between mobile phone and device, device and router;
▪
Try to connect another Wi-Fi network.
If network config fail,
the page will turn to
"Config timeout"
8 / 15