Advertisement
Please note：
You must read this instruction manual carefully before installation to ensure you can
install and use your battery correctly.
This document describes how to configure Pelio-L-5.12 of the Wi-Fi logger and how to set up the
Pylontech Home APP.
Step 1: Install Wi-Fi logger
1. With the front of the logger (with the label) facing outwards, insert it into the WI-FI USB port;
2. Rotate the nut on the top of the logger clockwise until the buckle fits into the card slot, then rotate the
nut half a turn to lock the WI-FI logger.
Please note: The white button on the front of the WI-FI logger (Logger Button) is used to trigger some
functions of the logger.
▪
Short Press (2s~6s): The NET LED flashes fast, logger enters network configuration mode.
▪
Long Press (over 10s)： Logger restore factory settings, only the STAT LED is on.
▪
The NET LED is on, the STAT LED flashes and the COM LED flashes intermittently, indicating that the
collector is working normally.
Refer to the table below to understand the status of the WI-FI logger indicator LED.
LED
Indicate the
communication
between the logger
and the battery
Logger
Button
LED Function
1. LED off: Indicates that the logger failed to
communicate with the battery
2. LED on: Indicates that the communication between
the logger and the battery has been successfully
established
3. LED fast flash: Indicates that the logger and the
battery are communicating.
3 / 15
Status Description
Advertisement
