Advertisement
Assembly Instructions (continued)
Lift the Hose Reel Assembly up and over the
8
fasteners so that the washer is on the inside of
the Hose Reel [FIG 8a].
Slide the Hose Reel Assembly down so that the
fastener is snugly inside the smaller section of
each keyhole [FIG 8b].
Tighten these four fasteners to secure the Hose
9
Reel Assembly to the wall [FIG. 9].
Note: If installing over drywall, avoid
overtightening as it may damage the wall.
Secure the Turn Key Hose Clamp (M) tightly
10
onto one end of the Hose (L) as shown in
[FIG. 10].
FIG. 8a
FIG. 9
FIG. 10
oneida-air.com
FIG. 8b
7
Advertisement
