Related Manuals for Oneida Air Systems AHR000025
Summary of Contents for Oneida Air Systems AHR000025
- Page 1 Rev: B 20230504LL Doc. #ZBI000054 InstructIon sHeet Hose Reel Wall Mount Supercell Mount #AHR000025 # AHK041425 Patents: www.oneida-air.com/patents Appearance may vary slightly 1-800-732-4065 oneida-air.com...
- Page 2 *You will need to supply your own wall mounting hardware. Use appropriate fasteners for the wall type you are installing your system onto (e.g. lag bolts, drywall anchors, etc.). Maximum Fastener Diameter: 3/8". Maximum Washer Outside Diameter: 5/8". Oneida Air Systems...
- Page 3 system contents (continued) Rev: C 20230504LL Hose Reel Template #ZBT000003 drill here drill here drill here leVel this line leVel this line 16" 406 mm 8-1/2" Hose reel template 216mm the hose reel should be mounted to a sturdy, reinforced wall (e.g. concrete wall, brick wall, wood-framed wall, etc.) Wall anchors can be used if mounting on drywall.
- Page 4 3/8" Screw (F) as shown in [FIG. 2]. FIG. 2 Secure the Outlet Coupler (E) to the Outlet & Brake Side Assembly (A4) using three 8-32 x 3/8" Screws (F) as shown in [FIG. 3]. FIG. 3 Oneida Air Systems...
- Page 5 Assembly Instructions (continued) Thread the Screw (D) through the Handle Side Assembly (A3), Spacer (C) and Handle (B) [FIG. 4]. FIG. 4 Identify where you will install the Hose Reel in your shop and how the hose reel will be Front View Front View oriented [FIG.
- Page 6 Maximum Washer Size: 5/8" outside diameter Place washers onto each fastener and thread the fasteners into all four holes, leaving at least 1/2" outside of the hole to fit the Hose Reel Assembly [FIG. 7]. FIG. 7 Oneida Air Systems...
- Page 7 Assembly Instructions (continued) Lift the Hose Reel Assembly up and over the fasteners so that the washer is on the inside of the Hose Reel [FIG 8a]. Slide the Hose Reel Assembly down so that the fastener is snugly inside the smaller section of each keyhole [FIG 8b].
- Page 8 FIG. 11a Hose Clamp on the Outlet Coupler [FIG 11c]. Note: To permanently install the Hose, silicone can be applied to the Hose's cuff prior to being inserted into the Outlet Coupler. FIG. 11b Interior View FIG. 11c Oneida Air Systems...
- Page 9 Assembly Instructions (continued) Secure the Hose (L) to the Handle Side Assembly (A3) with the Self-Drilling Screw (K) and 3" Loop Clamp (J) as shown in [FIG 12]. Note: DO NOT screw into recessed portions of the Core (A1). FIG.12 Guide the Hose (L) as you wind it around the Core (A1) of the Body Assembly (A) so it is neatly wrapped as shown in [FIG.
- Page 10 Regardless of where you purchased your system, if you have any questions or issues with missing / damaged parts, please call Oneida Air Systems first to let us help resolve your problem. We fully stand behind the quality of our product and place the utmost value on our customer’s satisfaction.