Table of Contents
Advertisement
6.9 Electrical connections
All devices, supply included, must be installed up to standard and in compliance with the regulations in force. Separate the power
cables from the control cables, above all if the paths are long (over 50m). As to the cable section (aerial excluded), TAU recom-
mends: supply 1.5mm², other cables 0.5mm², follow anyway IEC 364 and the installation regulations in force in your country. To
access the control card, remove the cabinet cover after removing the locking screws and washers. It is then possible to reach the
connections.
Note: internal connections are already made and tested. The supply, external photocell, LEDs and any remote controls
must be connected and the card must be programmed.
6.10 Electric limit switches - adjustment (LUXE-SE)
6.11 Mechanical stops adjustment
A
The barrier is normally supplied with the mechanical stops already adjusted for the ideal movement of the bar.
In the event that the foundation plate is incorrectly positioned, the bar may not be perfectly horizontal or vertical thereby giving
the barrier an unpleasant appearance.
1
2
The electric limit switches installed on the LUXE-SE are used
to set the beginning of the soft stop during opening and
closing. To adjust the cams which trigger the limit switches
(1) move them around the housing ring (2) until the desired
position is reached.
To adjust the limit switches, it is also necessary to set the
logic parameters of the controller. For example, if the boom
stops immediately after the limit switch has been activated
it will be necessary to increase the motor torque (see "logic
adjustments" on the K101M controller's manual); on the
other hand, if the motor does not shut off once the closing
or opening is complete, it will be necessary to increase the
limit switch detection threshold (see "logic adjustments" on
the K101M controller's manual).
B
21
Advertisement
Table of Contents
