Table of Contents
Advertisement
TAKING A MEASUREMENT
Multiple methods can be used to take a measurement with the Yo-Yo, automatically or manually. The Yo-Yo level
sensor also has the ability to offer a variety of remote measurement options.
USING THE REMOTE DISPLAY (IMMEDIATE MEASURE)
The Remote Display is capable of monitoring up to 99 sensors.
1. Press left/right arrow keys in Operating Mode section of the key pad to move to the desired sensor
address. Holding a key down will scroll through the sensors quickly.
2. Press the Measure key in the Operating Mode section of the key pad. The initial indication should read
"Starting Measure" followed by "Sensor is Measuring"
3. When the measurement is complete, the reading will be updated. Status should read "Sensor is
Normal".
AUTO-TIMER MEASUREMENT
Please use caution when using this feature; sending the sensing weight to the material surface should not be
done while the vessel is filling. It is strongly recommended to use the Inhibit Feature when Auto-timer is on. See
Electrical Section for details.
1. Press left/right arrow keys in Operating Mode section of the key pad to move to the desired
sensor address. Holding a key down will scroll through the sensors quickly.
2. Push Program on the key pad.
3. Enter the password. Password is 1936 (The system does not allow changes to the password at this time.)
4. Press ENTER.
5. Use the arrow buttons to place the asterisk (*) beside 'Set Auto-timer Mode' and press ENTER.
6. Use arrows to set time (duration period can range from from once every 2 minutes to 9999 minutes
(approximately 1 week).
7. Press ENTER. The Yo-Yo will now automatically take measurements as requested.
14
www.bindicator.com
LBY180112 Rev. B
Advertisement
Table of Contents
