To Program A Sensor; Settings Menu - Bindicator Mark-4 Installation & Operation Manual

TO PROGRAM A SENSOR

1. Press left/right arrow keys in Operating Mode section of the key pad to move to the desired sensor
address. Holding a key down will scroll through the sensors quickly.
Note: One sensor must have an address of 01 or unit will not communicate with the system.
2. Push Program on the key pad.
3. Enter the password. Password is 1936 – the system does not allow changes to the password at this time.
4. Press ENTER.
5. Use the arrow buttons to place the asterisk (*) beside the desired selection and press ENTER. To move
back press ESC.
Note: After one minute, unit will revert back to previous settings; can be used if mistake has been made to
reset.
Note: For a multiple sensor system, all sensors need to be enabled individually.

SETTINGS MENU

• Set Units
- Units
- Distance Units
- Engineering Units
• Set Tank Parameters
- Tank Height
- Tank Full Distance
- Tank Empty Distance
- Maximum Move Distance
- Cone Height
- Full Scale Value
• Display Mode
- Material
- Air
• Set 4-20 mA Mode
• Set Autotimer Mode
- Autotimer Time
• Set Sensor Name
• En(able) /Disable Sensors
• Save & Quit
LBY180112 Rev. B
13
www.bindicator.com