Table of Contents
Advertisement
26 Mechanical installation
1.
Stop the drive and do the electrical safety precautions in the drive safety
instructions.
2.
Pull out the lock.
3.
Put the module carefully into its position on the control unit until the retaining
clips lock it into position.
4.
Push in the lock.
5.
Torque the screw to 0.8 N·m (7.1 lbf·in).
Note: The screw tightens the connections and grounds the module, which is
necessary for fulfilling the EMC requirements and for correct operation of the
module.
WARNING!
Do not tighten the screw too much. If you tighten it too much, you can cause
damage to the threads.
For more information, refer to the drive hardware manual.
WARNING!
Do not install the FPTC-02 module on an FEA-03 F-series extension adapter.
The diagnostics of the module requires that you install it directly on the control
unit.
2
5
4
3
Advertisement
Table of Contents
