Selecting The Installation Location - BST ekr 500 digital Installation And Commissioning Manual

6.2

Selecting the Installation Location

Do not climb onto or walk on BST components or unsuitable
►
parts of the machine.
Ensure that there is sufficient free headroom. If the free head-
►
room is restricted, the relevant components causing the height
restrictions must be padded and danger-warning signs must be
attached to them (yellow / black).
After completing the installation work
Install all safety equipment and protective covers that had to
►
be removed for the installation work.
Check that the bolts are screwed tight.
►
Remove all tools and auxiliary aids used from the machine.
►
Before commissioning, remove any transport locks present
►
from the BST components.
DANGER
Danger of death when operated in potentially explosive areas!
The system must not be installed or operated in potentially
►
explosive areas.
In addition to the basic ambient conditions (see Ambient Condi-
tions, page 28), the following conditions also have to be fulfilled:
Installation location dry, vibration-free and level
■
Ergonomic positioning of the control panel
■
No direct light irradiation onto the display of the control panel
■
Minimum clearance of 100 mm to electro-magnetic fields
■
(energy sources or high voltage lines)
No sources of heat in the immediate vicinity
■
ekr 500 digital Unit Touch – Installation and Commissioning Manual
6
Installation
45/162