Advertisement
6 6
GETTING STARTED
I
O
I I
I
Fill
Insert
Eject
I
O
I I
I
Pressure
Setting
Charging Unit Prior to First Use
Charge Unit For 24 Hours Prior To First Use. A user supplied USB carger with the following specifications is required to charge this product:
USB Type-A, Rated Output: 5.0 VDC, 1.0 A. Plug the USB charger into a wall outlet and connect the charging cord to the unit. Make sure
you slide the switch into the OFF (0) position before charging. The unit will not charge if the switch is in the ON (I) position. See "Cleaning
and Troubleshooting Your Waterpik® Water Flosser" for guidance on how to look after your battery.
Filling the Reservoir
Lift flip top on reservoir and fill the reservoir with lukewarm water.
Inserting and Removing Tips
Insert tip into the center of the knob at the top of the Water Flosser handle. The colored ring will be flush with the end of the knob if the
tip is correctly locked into place. To remove the tip from the handle, press the tip eject button and pull tip from the handle.
CAUTION:DO NOT PRESS TIP EJECT BUTTON WHILE UNIT IS RUNNING.
Adjusting the Pressure Setting
You can adjust the pressure setting on your Water Flosser by simply sliding the pressure switch on the handle.
Advertisement
