Acoustic Signal; Switching On And Off; Display Illumination - Parkside PLEM 50 A1 Operating Instructions Manual

Acoustic signal

Each press of a button and every error-free function that is carried
out is confi rmed by a short beep.
A longer beep is only heard in the event of a fault and when switching off .
Switching on and off
♦ To switch the device on, press the ON
When the device is switched on, the laser beam is not yet
activated.
To switch the device off , press and hold the OFF C
♦
If no button is pressed for about 3 minutes, the device turns off auto-
matically to save the batteries.
If measured values have been saved, they are retained in the case of
automatic shut-off .

Display illumination

To improve readability, the display
By pressing the
on and off .
PLEM 50 A1
button , the display backlight can be switched
UNIT
button
ON
OFF
is equipped with a backlight.
GB
.
button .
53