Maintenance And Storage - Intec 980951 Manual

instructions (5.1 ).
11. Once the battery is charged, press the «
The LED will turn off to show that the battery charger has completed the work cycle.
12. Disconnect the power supply lead of the appliance from the mains socket.
13. Disconnect the output lead with the black clamp from the motor vehicle's earthing
point or from the negative terminal (-) of the battery.
14. Disconnect the output lead with the red clamp from the positive terminal (+) of the
battery.
5.1 Intentional interruption of charging cycle
If you want to interrupt the battery charging cycle, simply press the «
corresponding LED will switch off to show that the work cycle has ended. Disconnect the output
lead of the appliance from the mains socket and the output leads from the battery terminals.
5.2 Interruption of charging cycle in case of a power supply cut
In the case of a mains power supply cut, the battery charger saves the work cycle it was
performing in order to restore it automatically (only in the «
supply is restored. This feature is fundamental if the battery charger is used to charge batteries
without the operator supervising the cycle; for example, during very long charging cycles.
Whereas, in the « Charge
work cycle.

6. MAINTENANCE AND STORAGE

Disconnect the battery charger from the battery and supply mains. Clean the enclosure with a
soft, dry cloth before storage.
When the battery charger will not be used for a long time, it must be stored in a dry place to
protect it against humidity and moisture.
Electrical products should not be discarded with household products. Electrical
products used must be collected separately and disposed of at collection points
provided for this purpose. Talk with your local authorities or dealer for advice on
recycling.
EN
» mode, the « Start/Stop
- 15 -
Start/Stop » button of the battery charger.
Flash » mode) as soon as the power
» button must be pressed to resume the
Start/Stop » button; the